Three Phase Boring Machine
Boring is a machine process performed to enlarge
the diameter of an existing hole. A three phase boring machine is
usually a larger machine that is used for larger productions. There are
several types of three phase boring machines that include: line
boring, tunnel boring, horizontal boring, directional boring, cylinder
boring, jig boring, and vertical boring, among others. A three phase
boring machine will make a hole the proper size and finish. Since
size is determined by the applications of the three phase boring
machine, the required finish requires the right blend of speed, feed
and noise radius. The three phase boring machine straightens an
original drilled hole or cored hole. This in turn corrects any defects
in the castings or any drilled holes that are not centered. A three
phase boring machine centers the hole with the outside diameter
which is being held in the holding device.
Horizontal three phase boring machines are
used to horizontally bore large work pieces. It was designed to bore,
ream, drill, counter bore, tap holes and face a part. They are actually
pretty versatile. Vertical three phase boring machines are again
used on very large parts that can cut and contour using this type. The
diameter of the part that is being bored is limited though by the
diameter of the three phase boring machine table.
A jig three phase boring machine is used for holes that have a
very tight diameter. This type of three phase boring machine can
maintain high accuracy between multiple holes and surfaces. Three phase
tunnel boring machines are the extreme to the boring machines. They are
used to excavate tunnels with a circular cross section through any type
of soil and rock. They are used as the alternative to blasting and
drilling.
A three phase boring machine must be used with three phase power.
That is where the true three phase rotary phase converter may apply.
Since three phase power isn't always available to certain locations from
the utility companies, a phase converter is your answer. The true three
phase rotary phase converter converts the single phase power source into
three phase power. This allows your three phase boring machine to now
run on the correct power source that it needs. There are all types of
sizes available on the market today to achieve your three phase power
load for your three phase boring machine whether it be small or large.
The three phase rotary phase converter can be used to run several
different equipment pieces at the same time. Just make sure that when
purchasing a three phase rotary phase converter, that it is actually
true three phase power. A true three phase rotary phase converter will
have a 3-phase rotating generator with power factor correction. This
will ensure that your equipment will run smoothly and efficient with
little or no maintenance for years to come.
ACE
Phase Converter has been manufacturing the true three phase rotary
phase converter for over 25 years. They can guarantee that you are
getting true three phase power with their phase converters. There is a
full time staff that is there to help you select the correct size phase
converter for your three phase boring machine. They use quality
materials in all of their products such as 100% windings and wiring.
Each component is made right here in the United States. They stand
behind all of their phase converters by offering a 10 year warranty on
each and every one. So make sure that your three phase boring machine
has the best possible power solution to ensure long lasting performance,
give ACE Phase Converter a call at (800) 967-7217
Bookmark This Site:
Three Phase Boring
Machine
Other Resources
◙
Rotary Phase Converters
◙
Robin
Generator
◙
Isolation
Transformers
◙
Variable Frequency Drives
◙
Diesel
Generators
◙
Power
Generators
◙
Step Down Transformers
◙
Electrical Transformers
◙
Static
Phase Converter |
