Three Phase Edge Bander
The
three phase
edge bander is a
machine that applies a color strip or laminate on the edge of a piece of
wood. It is more often used with wood projects but can also be used with
different applications. One of the main applications that use the three
phase edge bander is the furniture industry.
The
three phase edge bander
has what they call a squaring area. This guarantees perfect preparation
of the panel before the edgebanding phase. There is an anti-adhesion
unit on the three phase edge bander that applies a liquid to the
top and bottom of the panel. This facilitates any removal of any
residual adhesive. There is usually a double chipper and splinter
remover on the
three phase edge bander
as well, which prevents any formation of splinters along the entire
panel of wood or material profile.
After these treatments are
done, the panel is now ready to move to the glue unit. The glue descends
from the pre-melting unit directly into a bowl on the
three phase edge bander.
There is a sensor that adjusts the amount of glue that is present. The
glue is now heated usually to a temperature of 220 degrees. The
three phase edge bander
collects a portion of the glue and spreads it onto the edges of the
panel. The three phase edge bander has now applied the pre-glued
edge material to straight and curved workpieces.
The
three phase edge bander
is one of the most consistent products on the market today. Some of the
typical applications used with the
three phase edge bander
are residential, office furniture, store fixtures, kitchens, locker
rooms, laboratories, hospitals, schools, furniture industry and numerous
others.
The
three phase edge bander
was designed to operate on three phase power. Calling a utility company
to install three phase power can be very expensive, so the best bet is
to purchase a three phase power converter. Make sure that it is
true three phase power because if not, just start-up three phase power
will only be supplied. In order to get that true three phase power, the
phase converter must have a 3-phase generator with power factor
correction. The reason why a three phase power converter is
recommended is so that your
three phase edge bander,
along with any other equipment, will run smoothly, safely and more
efficiently. The true three phase converter takes that single phase
power and converts it into true three phase power.
Always look for a good reputable
manufacture, like ACE
Phase
Converter, when
purchasing a phase converter. They don't sell a phase converter without
true three phase power. All of their technicians and engineers have been
highly trained in the phase converter department. They stand behind each
product by offering a 10 year warranty on them. ACE Phase Converter has
been solving three phase power solutions worldwide for over 25 years.
You can be assured that your
three phase edge bander
will last you for years to come with an ACE Phase Converter.
Bookmark This Site:
Three Phase Edge Bander
Other Resources
◙
Rotary Phase Converters
◙
Robin
Generator
◙
Isolation
Transformers
◙
Variable Frequency Drives
◙
Diesel
Generators
◙
Power
Generators
◙
Step Down Transformers
◙
Electrical Transformers
◙
Static
Phase Converter |
