Three Phase Film Processor
A
three phase
film processor is
a machine used for developing film whether it be from cameras or x-ray
machines. The three phase film processor is run on a continuous
basis in which the film is spliced together in a continuous line. The
three phase film
processor uses a
controlled time, temperature and a solution replenishment rate. The film
gets washed in a solution, which is a developer, bleach solution. It
will then go through a dryer and then the film is ready to be
automatically cut by the the three phase film processor and
printed.
There is a process called the dip
and dunk process, as opposed to a roller process which is called a cine
type
three phase film processor.
The dip and dunk process on a
three phase film processor
was designed for short rolls of film and also sheet film. The racks on
the three phase film processor are loaded with the film and then
a transport arm slowly immerses the film into a tank with air or gas
bursts which agitates the chemistries. The transport arm on the
three phase film processor
now lifts and continues the cycle into the tanks of chemicals. After
this is completed, the three phase film processor now sends the film to
the drying cycle. This type of process on a
three phase film processor
leaves little opportunity for the film to be scratched or damaged.
The
three phase film processor
is used to develop 35MM film along with high quality radiographs that
are used for imaging sites such as diagnostic centers and private
practice offices. They can be used by dentist offices, mammograms, and
any other office that has the need for conventional imaging of film.
The
three phase film processor
should be operating with three phase power. A phase converter is a
good choice to use when using the
three phase film processor.
A phase converter will take the single phase power source that is
supplied and convert it into true three phase power. Always make sure
that you are getting that true three phase power, otherwise, your
three phase film processor
will only work on three phase power in the initial start-up phase. If
the phase converter has a 3-phase generator with power factor
correction, you can guarantee that you are getting true three phase
power. This will result in smooth, balanced, three phase electricity
getting to your three phase
film processor. Your
equipment will operate safely and much more efficient with this type of
power.
Sometimes it is very difficult to
find a good quality manufacturer that makes a true three phase
converter. That problem is solved if you visit
ACE
Phase
Converter.
They have been manufacturing the true three phase converter for over 25
years and they have many selections to choose from, depending on the
size and load that you will need to power your
three phase film processor.
ACE Phase Converter stands behind every product that they sell by
offering the consumer a 10 year warranty.
Bookmark This Site:
Three Phase Film
Processor
Other Resources
◙
Rotary Phase Converters
◙
Robin
Generator
◙
Isolation
Transformers
◙
Variable Frequency Drives
◙
Diesel
Generators
◙
Power
Generators
◙
Step Down Transformers
◙
Electrical Transformers
◙
Static
Phase Converter |
